Car stickers

Yes, that’s what this page is for. Work on a clean, dry surface and smooth the film down from the centre towards the edges. Larger areas are easier to apply when wet. The white ‘easy stickers’ have repositionable adhesive dots, allowing you to adjust their position whilst applying them. Make sure the car is clean, dry and not cold, otherwise the adhesive won’t stick properly.

That depends on the film. Monomer vinyl is intended for temporary use and lasts for 2 years; polymer vinyl lasts for 5 years; and cast vinyl lasts for 7 years. One-way vision film on a window lasts for 3 years. If you let us know how long the sticker needs to last, we’ll choose the right film.

This page is about small jobs: one or a few stickers that you apply yourself. Vehicle graphics, on the other hand, cover the entire vehicle – from a simple logo to a full car wrap – and we take care of the measuring and fitting, either at our premises in Lokeren or at your location.

Polymer vinyl works well on a slightly curved surface. For heavily curved parts, cast vinyl is required, as it is the only film in the range designed for three-dimensionally curved surfaces. On a flat door or a flat side panel, monomer or polymer vinyl is sufficient.

Magnetic film leaves no adhesive residue, as it does not contain any adhesive. The white ‘easy’ stickers have a repositionable adhesive. For permanent vinyl films, how easily they can be removed depends on the surface and how long the sticker has been in place, so please check this in advance if the car needs to be left blank again later.

With one-way vision, yes. This film is perforated, so you can still see out from the inside, whilst the view from the outside is largely obscured. You can find out more about this under ‘one-way vision’.

Yes. These stickers are not listed as a standard option in the ordering module, so please let us know what size you need and where the sticker will be applied. We print them in-house in Lokeren, even if it’s just a single copy.

This is possible with all vinyl films in this range. A laminate protects the print from scratches caused by brushes in the car wash and from UV light. With cast vinyl, this protective layer is standard.

Limited to the width of the wrap. For an image that runs across the entire side of the vehicle, you’ll need vehicle graphics, as we use panels and a specific installation method for this.

The vinyl films are made of PVC. The 0.5 mm magnetic version is available in a PVC-free version, and this is a perfectly viable alternative for a standalone logo on a car door.

This is usually the case with a laminated sticker that has been pressed down firmly. Do avoid high pressure for the first week after application, and never point the lance directly at an edge afterwards.